To change the speaker cord

If you want to change the speaker cord, you can detach the supplied speaker cord from the connector.

1 Press the connector onto a flat surface.

Make sure that the catcher is facing the flat surface.

catcher

2 Pull the speaker cord from the connector.

3 Twist the stripped ends of the speaker cord you want about 10 mm and insert the speaker cord into the connector.

Make sure that the speaker cord is inserted according to its polarity : + to + and – to –. Otherwise the sound will be distorted and will lack bass.

+(+)

–

(–)

4 Remove the connector from the flat surface.

Note

To avoid the speaker cord from coming off the speaker connector

–do not use a smaller-size speaker cord. We recommend that you use the AWG#18 to AWG#24 speaker cords.

–use the same speaker cord size for all the speaker connectors.

–twist the stripped ends of the speaker cords.

–insert the speaker cord completely into the speaker

connector.

4:Connecting the AC power cord

Connecting the AC power cord

Connect the AC power cord to a wall outlet.

AC power cord

To a wall outlet

Performing initial setup operations

Before using the receiver for the first time, initialize the receiver by performing the following procedure.

This procedure can also be used to return settings you have made to their factory defaults. Use the buttons on the receiver for the operation.

1 Press ?/1 to turn off the receiver.

2 Hold down ?/1 for 5 seconds.

“INITIAL” appears in the display. The following are reset to their factory settings.

•All settings in the SET UP, LEVEL and TONE menus.

•The sound field memorized for each input and preset station.

•All sound field parameters.

•All preset stations.

•MASTER VOLUME is set to “VOL MIN”.

14GB