TRACK/ | ALARM | ALARM | ALARM | |
CLOCK | | A | B | MODE | |
TIME SET/TRACK | | |
| | | | WAKE UP | |
| | | | TRACK | |
| POWER ON | | OFF / | |
CD ·∏ | RADIO/SLEEP | ALARM RESET | |
| | SNOOZE/SLEEP OFF | |
LIFT OPEN | | | | | |
| | | | VOLUME | |
| | | | AC power cord |
| | | | FM wire antenna |
| | | | TUNING | |
| | | | AM | FM |
| | | | BAND |
Playing the Radio
1.Press RADIO/SLEEP to turn on the radio.
The “RADIO” indication will appear and the “On” indication will appear in the display. After 10 seconds, the indication becomes the current time but the “RADIO” indication remains.
2.Adjust VOLUME.
3.Select the BAND.
4.Tune in a station using the TUNING dial.
•To turn off the radio, press OFF/ALARM RESET.
•To improve radio reception
FM: Extend the FM wire antenna to improve FM reception.
AM: Rotate the unit horizontally for optimum reception. A ferrite bar antenna is built into the unit.
Setting the Alarm
You can set the CD, radio and buzzer alarms at the preset time. Before setting the alarm, be sure to set the clock. (See “Setting the Clock”.)
Setting the Alarm Time
To set the 


alarm
1.While holding down ALARM A, press either TIME SET/TRACK + or – until the desired time appears in the display
window.
The “ 


” indication flashes and “:” lights.
2.Release ALARM A. The alarm time is set and the indication becomes the current time.
3.While holding down WAKE UP TRACK, set the desired track by pressing =or + beside TIME SET/TRACK.
4.Release WAKE UP TRACK. The track is preset and the indication becomes the current time.
Note
When the CD player is preset to start with track 5, it will always start with track 5 even though you change the CD, unless you change WAKE
•When the radio alarm is activated, the
“ 




” indication flashes. If you want to keep on listening to radio and stop flashing,
press RADIO/SLEEP. The “ 




” indication remains.
•The buzzer sound level is fixed, and independent of VOLUME.
To Doze for a Few More Minutes
1.Press SNOOZE/SLEEP OFF. The CD, radio or buzzer will shut off but will be activated automatically after about 8 minutes. You can repeat this process as many times as necessary.
•While SNOOZE/SLEEP OFF function is operating, the alarm indication flashes.
To Use Both Sleep Timer and Alarm
You can fall asleep to the radio and you will be awakened by the CD, radio or buzzer alarm at the preset time.
1.Set the alarm. (See “Setting the Alarm”.)
2.Set the sleep timer. (See “Setting the Sleep Timer”.)
Setting the Sleep Timer
You can enjoy falling asleep to the radio using the built-in sleep timer that turns off the radio automatically after a preset duration.
1.Press RADIO/SLEEP repeatedly. The radio turns on and the “On” indication will appear initially in the display. The radio will turn off automatically after the selected preset duration has elapsed.
Each time you press RADIO/SLEEP, the duration changes as follows.
Radio on
90 min
60 min
30 min (Sleep timer off)
Radio off
15 min
•To turn off the radio before the preset duration has elapsed, press SNOOZE/SLEEP OFF.
Troubleshooting
Setting the Clock
Set the time when the CD or radio is turned off.
1.Plug in the unit.
The display will flash “AM 12:00”.
2.While holding down TRACK/CLOCK, press either TIME SET/TRACK + or – until the correct time appears in the display.
When you release TRACK/CLOCK, the clock begins to operate and “:” flashes.
•To set the current time rapidly, keep pressing the + or – button while holding down TRACK/ CLOCK.
•To set the current time from zero seconds, at step 2, release TRACK/CLOCK with the time signal.
Playing a Disc
An 8 cm (3-inch) CD can be played without an adaptor.
Locating a Particular Portion
Locating a particular selection (AMS*)
To locate the beginning of the current selection, press =.
To locate the next selection, press +.
Locating a particular point in a selection (SEARCH)
To go back at high speed, keep = pressed. To go ahead at high speed, keep + pressed.
*AMS is the abbreviation of Automatic Music Sensor.
•If you press = repeatedly, the player locates the previous selections. If you press + repeatedly, the player locates the next selections and stops at the last selection.
•To stop play, press OFF/ALARM RESET.
•To pause, press CD fl and the “CD ( “ indication flashes. To resume play, press CD fl again.
•To change the clock mode to track mode, press
TRACK/CLOCK.
Press TRACK/CLOCK again, and the current time appears.
•To eject a disc, lift LIFT OPEN.
•To handle compact discs This way
Guide
Should any problem occur with the unit, make the following checks to determine whether or not servicing is required. If the problem persists, consult the nearest Sony dealer.
The clock does not show the correct time.
•There was an electrical power interruption lasting for more than 1 minute.
The CD player does not operate.
•Did you place a disc correctly?
The disc should be placed with the labelled surface up.
•Did you close the compartment lid completely?
•Dusty or defective disc—Clean the disc with an optional cleaning cloth. Wipe the disc from the center out.
Skipping of sound in CD operation
•Dusty or defective disc—Clean the disc.
•Dirty lens—Clean the lens with a commercially available blower.
•Strong vibration
The CD, radio or buzzer alarm does not activate at the preset time.
• Did you set the current time correctly? |
1.Lift LIFT OPEN to open the CD compartment lid and place a disc.
Lift.
Label surface up.
Close the lid.
2.Press CD fl and the display lights “01”. The current number (01 to 99) appears in the display window. After 10 seconds, the indication becomes the current time, but the “CD (“ indication remains.
3.Adjust VOLUME.
Handle the disc by its edge.
Not this way
Do not touch the surface.
Do not stick paper or tape nor write anything on the surface.
Notes
•Do not open the CD compartment lid while playing, otherwise, the disc will be damaged. Be sure to stop the disc first.
•When you press CD fl, if there is no disc in the CD compartment, the “00” indication flashes for 10 seconds and the unit will be turned off.
•If the 


alarm is activated while listening to the CD, the track changes to that preset by pressing WAKE UP TRACK.
•To stop the alarm, press OFF/ALARM RESET. The alarm will sound at the same time the next day.
•To cancel the alarm, while holding down
ALARM MODE, press OFF/ALARM RESET.
•To check the alarm time you set, press ALARM A or ALARM B.
Notes
•The alarm does not function, unless you set the
clock and 


/ 




/
alarm.
•If you set the CD alarm and radio or buzzer alarm at the same time, the CD alarm sounds.
•When you set the CD alarm, if there is no disc in the CD player, the buzzer will sound at the time you set.
•The selected alarm is activated at the time you set, and automatically turns off after 60 minutes.
•When the CD alarm comes on, the “ 


” indication flashes.
If you want to stop flashing, press CD fl. The CD player will stop playing at the last track.
• Did you set the alarm time correctly? |
• Did you place a disc? |
• Did you close the CD compartment lid |
completely? |
• Did you adjust the volume? |
If the volume is turned down completely, the |
CD or radio alarm is not heard. |