4 Press F/f to select the country/region in which you will operate the TV, then press 
.
Auto Start Up
Language
Country
Back: 
Select:
Confirm:
If the country/region in which you want to use the TV does not appear in the list, select
acountry/region.
7:Auto-tuning the TV
1 Before you start
The video channel will be located and stored on the TV during
If no VCR is connected to the TV, skip this step.
2 Press 
.
Do you want to start automatic tuning?
Back: | Start: | Cancel: MENU |
|
|
|
3 Press F/f to select “Antenna” or “Cable”, then press 
.
If you select “Cable”, the screen for selecting the scan type appears. See “To tune the TV for Cable connection” (page 6).
The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not press any buttons on the TV or remote while proceeding.
If a message appears for you to confirm the aerial connection
No digital or analogue channels were found. Check all the aerial/cable connection and then press 
to start
4 When the Programme Sorting menu appears on the screen, follow the steps of “Programme Sorting” (page 26).
If you do not change the order in which the analogue channels are stored on the TV, go to step 5.
5 Press MENU to exit.
The TV has now tuned in all the available channels.
~
When a digital broadcast channel cannot be received, or when selecting a region in which there are no digital broadcasts in step 4 (page 6), the time must be set after performing step 5.
To tune the TV for Cable connection
1 press 
.
2 Press F/f to select “Quick Scan” or “Full Scan”, then press 
.
"Quick Scan" : channels are tuned according to the cable operator information within the broadcast signal.
Recommended setting for "Frequency", "Network ID" and "Symbol Rate" is "Auto".
This option is recommended for fast tuning when supported by your cable operator.
If the "Quick Scan" does not tune, please use the "Full Scan" method below.
"Full Scan" : All available channels are tuned and stored. This procedure may take some time. This option is recommended when "Quick Scan" is not supported by your cable provider.
For further information about supported cable providers, refer to support web site:
3 Press G/g/f to select “Start”.
The TV starts searching for channels. Do not press any buttons on the TV or remote.
~
Some cable providers do not support “Quick Scan”. If no channels are detected using “Quick Scan”, perform “Full Scan”.
Detaching the Table- Top Stand from the TV
~
Do not remove the