51
Other Information
Troubleshooting
Many of the poor pictures and poor sound conditions are related to improper connect ion of the cables; refer to
the Quick Setup Guide provided for connections.
If you have questions, service needs, or require technical assistance related to the use of your Sony TV even
after you read this operating instructions manual, contact the following:
For US Support:
http://www.sony.com/tvsupport or call 1-800-222-SONY (7669)
For Canadian Support:
http://www.sony.ca/support or call 1-877-899-SONY (7669)

Things to consider

• Check the input selection by pressing the INPUT button. You may be watching the wrong input.
• If you cannot hear sound from the TV, you may have accidentally pressed the MUTING button on your
remote control; press the MUTING button again or press VOL + to deactivate muting.
• If the remote control is not functioning properly, the batteries may be installed incorrectly or may be low or
an object or light may be interfering with the remote control.
• To reset the TV to factory default settings:
1Turn on t he TV.
2Press and hold down the V button on the remote, press the 1 button on the TV set. (The TV will turn
itself off, then back on again.)
3Release the V button when the TV is turn on.
IMPORTANT: The factory reset will clear all of your customized settings including the Parental Lock
setting.
When the Password is lost or cannot remember, enter the master password: 4357. This password clears your
previous password and allows you to enter a new password.
Condition Explanation/Solution
No picture
No picture • Check the Power Sav ing settings (see page 43).
Cannot receive any
channels
•Make sure the power cord is connected securely.
• Turn on the power of the TV.
• Check cable/antenna connections.
•Make sure the Signal Type setting is correct for your TV signal source.
TV is locked to one channel • Perform Aut o Program to add receivable channels that are not presen t
in the TV’s memory (see pages 17 and 35).
Cannot receive or select
channels
• Perform Auto Program to add receivable channels that are not present
in the TV’s memory (see pages 17 and 35).
• To receive or select cable channels, make sure that Signal Type in the
Channel settings is set to Cable (see page 35). To receive or select
UHF channels over an antenna, make sure Signal Type is set to
Antenna.
The TV turns off
automatically
•Check if Sleep Timer is activated (see page 40).
•Check Idle TV Standby in the Eco settings.
No picture from some video
sources
•Check the connection between the optional video equipment and the TV.
• Press INPUT on the remote control (see page 26).
(Continued)