Distorted picture
/Check your video card manual for the proper monitor setting.
/Check that the frequency and the graphic mode of the signal you are trying to input is within the acceptable range. (page 9)
Even if the signal is within the proper range, some video cards may have a sync pulse that is too narrow for the monitor to sync correctly.
No picture, no sound from the connected equipment
/Are all of the cords connected correctly?
/Press the RGB, VIDEO or COMPONENT button on the remote control. (page 15)
The remote control does not function.
/Are the batteries worn out?
/If additional equipment is connected to the CONTROL S IN jack on the rear of the monitor, the remote control detector does not function. Disconnect any equipment connected to the CONTROL S IN jack. (page 13)
The humming noise of the fans is heard even after the monitor has been turned off.
/The fans installed inside the monitor are working to prevent internal heat
What the indicators on the front of the monitor mean
LAMP STANDBY
The u(power) (green), STANDBY (orange) and/or LAMP (orange) indicators indicate the condition of the monitor and provide warnings by lighting or flashing, as shown below.
The u indicator lights up.
/The power of the monitor is on.
The STANDBY indicator lights up.
/The monitor is in standby mode. The monitor is turned on by pressing 1/uon the remote control.
The u and STANDBY indicators light up.
/The AUTO SHUT OFF function is working. The monitor has been turned off when the time you specify has passed after the input from the computer is cut off.
The u indicator flashes.
/The lamp is preparing to turn on. Picture and sound will appear momentarily.
The LAMP and STANDBY indicators flash.
/The air filter or the lamp cover is not attached securely. When you secure the cover, the STANDBY indicator lights up and the LAMP indicator turns off. (pages
27 and 28)
The LAMP indicator flashes.
/The lamp for the light source has burnt out. Replace it with a new one. (page 28)
The LAMP, STANDBY and u indicators flash. The LAMP and u indicators flash.
The STANDBY and u indicators flash.
/Contact qualified Sony personnel and inform them of the monitor’s condition.