Advanced Operation - Advanced Presetting

Automatically Tuning the TV

Besides the explanation in the section “Automatically Tuning the TV using the Remote Control“, by following the instructions below, this projection TV also searches and stores automatically all available channels using just one button of the projection TV set and one button of the remote control.

1 Push up the flap on the front of the projection TV to reveal the front control panel.

VIDEO TV

1 2 3

4 5 6

7 8 9

0

PROGR

MENU

2 Press and hold in thebutton on the TV set for some seconds, until a menu appears automatically on the screen asking you to check that antenna is connected.

3 Confirm that the antenna is connected and then press the OK button on the remote control.

The automatic tuning starts and the message "AUTO

PROGRAMME" flashes on the screen.

This procedure could take some minutes. Please, be patient and do not press any button, otherwise the automatic tuning will not be completed.

When the automatic tuning procedure is complete, the Programme Sorting menu appears on the screen:

•If you do not wish to change the channel order, press the MENU button on the remote control to exit and return to the normal TV screen.

•If you wish to change the channel order, proceed in the same way as described in the chapter "Changing the Programme Order of the TV channels", section b).

Note: To stop the automatic tuning, press the MENU button on the remote control.

Please confirm that antenna is connected

Confirm: OK

Please confirm that antenna is connected

Confirm: OK

AUTO PROGRAMME

PROG SYS CH LABEL

1B/G C 26 - - - - -

AUTO PROGRAMME

RM 892

S

14 Advanced Operation - Advanced Presetting