![Operating a Cable Box](/images/new-backgrounds/37413/3741361x1.webp)
Operating a Cable Box
Programming the remote
You can program the supplied remote control
to operate a cable box or DBS receiver.
1 Press CODE SET.
2. Press DBS/CABLE (FUNCTION).
3 Use the
manufacturer's code number from the
following chart.
4 Press ENTER.
For more details on operating the cable box or DBS receiver
Refer to the operating instructions that were supplied with the equipment.
or DBS Receiver
If the remote control doesn't work
• First, try repeating the setup procedures using the other codes listed for your equipment.
Tips "0"
•If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.
•Ifyouenteranewcodenumber,thecodenumber you previously entered at that setting is erased.
•In some rare cases, you may not be able to operate your equipment with the supplied remote control.
In this case, use the equipment's supplied remote control.
•Wheneveryouremovethebatteriesthecode numbers may revert to the factory setting.
Cable box code numbers
Manufacturer |
| Code | ||
Hamlin/Regal | 222, 223, 224, 225, 226 | |||
Jerrold/G. | I. | 201,202, 203, 204, | 205, | 206, |
|
| 207, 208, | 218 | |
Oak |
| 227, | 228, | 229 |
Panasonic |
| 219, 220, | 221 | |
Pioneer |
|
| 214, | 215 |
Scientific | Atlanta | 209, | 210, | 211 |
Tocom |
|
| 216, 217 | |
Zenith |
|
| 212, | 213 |
DBS receiver code numbers
Manufacturer |
| Code | ||
Sony | 80I (preset | code | for | |
remote | control) | |||
| ||||
General Electric |
|
| 802 | |
|
| 805 | ||
Hitachi |
|
| ||
|
| 804 | ||
Hughes |
|
| ||
|
| 803 | ||
Panasonic |
|
| ||
|
|
| ||
RCA/PROSCAN |
| 802, | 808 | |
| 806, | 807 | ||
Toshiba |
| |||
|
|
|
28