Sony KV-VF21M40 Removal of anode-cap, removing procedures, 2-6. PICTURE TUBE REMOVAL, how to handle an anode-cap

– 67 –
• Removal of anode-cap
NOTE : Short circuit the anode of the picture tube and the
anode cap to the metal chassis, CRT shield or car-
bon paint on the CRT, after removing the anode.
a
a
• removing procedures
b
b
c
2Using a thumb pull up the
rubber cap firmly in the
direction indicated by the
arrow b.
2-6. PICTURE TUBE REMOVAL
3 Chassis assmbly
4 CV board
6 Deflection yoke
9 Demagnetization
0 Two spring
!¡ Four screws
(Tapping screw 5)
!™ Picture tube
1 Anode cap
Cushion Cassette door
2 Two screws (+BVTP 4 X 16)
8 Two DGC clip
7 Top support
5 NA rotation coil
Note: Notice for Installing chassis assmbly
Install chassis assembly when keep
the cassette door open state.
1Turn up one side of the
rubber cap in the
direction indicated by
the arrow a.
3When one side of the rubber
cap is separated from the
anode button, the anode-cap
can be removed by turning
up the rubber cap and pulling
it up in the direction of the
arrow c.
• how to handle an anode-cap
1Don't hurt the surface of anode-caps with shaped
objects!
2Don't press the rubber too hard so as not to hurt inside of
anode-caps!
A metal fitting called the shatter-hook terminal is built into
the rebber.
3Don't turn the foot of rubber over too hard!
The shatter-hook terminal will stick out of damage the
rubber.