Sony xSetting up your TV (“Initial Setup”), Tip, Tips, V/v/B/b, Installation

xSetting up your TV (“Initial Setup”)

When you turn on your TV for the first time, the “Initial Setup” menu will appear. You may change the menu language, preset the TV channels automatically and adjust the picture position using the buttons on the TV front panel.

Tip

•The MENU, and V/v/B/b buttons on the remote control can also be used for the operations below.

1	Press 2 +/– to select the desired menu
	language, then press t.
	The selected menu language appears.
2	Press 2 +/– to select “Yes”, then press t
	to preset the channels automatically or
	select “No” to skip automatic channel
	presetting.
	Once you select “Yes”, your TV will start
	searching for all the available channels.
	If the message “No channel found. Please
	connect cable/antenna.” appears, check your
	TV connections, then press t.
3	Press 2 +/– to adjust the bars on the
	top and bottom of the menu if they are

slanted, then press t.

Installation

If no adjustment is necessary, then press t.

4 Press 2 +/– to select “No”, then press t. This menu will not appear again the next time you turn on the TV by pressing !.

To allow this menu to appear again, select “Yes”, then press t.

Tips

•You can immediately go to the end of the “Initial Setup” menu by pressing MENU.

•You can also set up your TV using the menu system (see page 12).

•You can also preset the channels automatically by pressing MENU (AUTO PROG) button on the TV front panel for about five seconds.

Installation 7