Sony KWP 65HD1 manual 78

Operating a Cable Box or DBS Receiver

Setting the Manufacturer's Code

You can program the supplied remote control to operate a cable box or DBS receiver.

Press CODE SET, DBS/CABLE (FUNCTION), and the 0-9 buttons to enter the manufacturer’s code number (see the following chart), then press ENTER.

For example, to operate a Sony DBS receiver:

CODE SET	FUNCTION		ENTER
	DBS/CABLE	0
	8		1

Manufacturer code numbers (DBS receiver)

Manufacturer	Code number
Sony	801 (preset code for
	remote control)
General Electric	802
RCA/PROSCAN	802

To operate the cable box or DBS receiver

1Press DBS/CABLE (POWER) (green labeled button) to turn on/off the cable box or DBS receiver.

Tips z

•If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.

•If you enter a new code number, the code number you previously entered at that setting is erased.

•In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s own remote control unit.

•Whenever you remove the batteries — to replace them, for example — if too much time is taken, the code numbers may revert to the factory setting and must be reset.

Manufacturer code numbers		2	Press DBS/CABLE (FUNCTION).
(cable box)		3	For other operations, refer to the
Manufacturer	Code		operating instructions that come with the
Gemini	233		equipment.
Hamlin/Regal	222, 223, 224, 225, 226
Jerrold/G. I.	201, 202, 203, 204, 205,	If the remote control doesn’t work
	222, 206, 207, 208, 218	•	Try repeating the set up procedures using
Macom	230, 231, 232
Magnavox	234		the other codes listed for your equipment.
Oak	227, 228, 229	To operate the projection TV
Panasonic	219, 220, 221
Philips	236, 237, 238, 239, 240, 241
Pioneer	214, 215	Press TV (FUNCTION). Then use the
Samsung	235	projection TV control buttons to control the
Scientific Atlanta	209, 210, 211
Tocom	216, 217	projection TV.
Zenith	212, 213

74