Sony KWP 65HD1 80

Troubleshooting (continued)

Good picture, no sound

•Press MUTING so that “MUTING” disappears from the screen.

(see “MUTING” on pages 29, 37)

•Check the MTS setting in the AUDIO menu. (see “MTS” on page 49)

•Make sure SPEAKER is set to ALL ON or L/R OFF in the AUDIO menu. (see “SPEAKER” on page 49)

•Perform AUTO SET UP again using “Auto Program” for digital channels, or using the SET UP button for conventional TV channels to return to the factory preset condition. (see “To perform AUTO SET UP again” on page 26)

No picture on a digital channel

• Switch to a different digital channel.

Cannot receive digital channels

•Press DTV ANT on the remote control so that the TV (FUNCTION) indicator lights up in green momentarily.

•Make sure that VHF/UHF antenna is connected to both VHF/UHF IN and VHF/ UHF (DTV) IN on the projection TV.

You cannot receive digital channels unless you connect an analog terrestrial antenna. This is true even if you normally receive your programming through cable or satellite.

•Use “DTV Auto Add” in the Channel Setup menu to add receivable DTV channels that are not presently in DTV memory.

•Make sure that the DTV I/O cable is connected to both the lower and upper panels at the rear of the projection TV.

•Check your local listings to find out if you can receive digital broadcasts in your area.

Unable to select a digital channel

•Use “DTV Auto Add” in the “Channel Setup” menu to add receivable DTV channels that are not presently in DTV memory.

Cannot receive conventional TV channels

•Press TV ANT on the remote control so that the TV (FUNCTION) indicator lights up in red momentarily.

Cannot receive upper channels (UHF) when using an antenna

•Make sure CABLE is OFF in the CHANNEL SET UP menu. (see “CABLE” on page 54)

•Use AUTO PROGRAM to add receivable channels that are not presently in the TV’s memory. (see “AUTO PROGRAM” on page 54)

No color

•Adjust the COLOR in the VIDEO menu. (see “COLOR” on page 47)

•Black and white programs cannot be seen in color.

Only snow and noise appear on the screen

•Check the CABLE setting in the CHANNEL SET UP menu. (see “CABLE” on page 54)

•Check the antenna/cable connections.

•Make sure the channel is broadcasting programs.

•Press TV ANT to change the input mode. (see “TV ANT” on page 36)

Dotted lines or stripes

•Adjust the antenna.

•Keep the projection TV away from noise sources such as cars, neon signs or hair- dryers.