16GB
Slide and remove the battery
compartment lid, then, insert the two
supplied R6 (size AA) batteries, E side
first, matching the polarities shown
below.
Notes
Do not mix an old battery with a new one or
mix different types of batteries.
If you do not use the remote for a long period
of time, remove the batteries to avoid damage
from battery leakage and corrosion.

Setting the clock

You cannot set the clock in Power Saving
Mode.
Use the buttons on the remote for this
operation.
1Press "/1 to turn on the system.
2Press CLOCK/TIMER SET
(RM-AMU053) or TIMER MENU
(RM-AMU054).
If “PLAY SET” appears on the
display, press ./>
(RM-AMU053) or V/v
(RM-AMU054) repeatedly to select
“CLOCK SET” and then press
ENTER (RM-AMU053) or
(RM-AMU054).
3Press ./> (RM-AMU053) or

V/v (RM-AMU054) repeatedly to

set the hour, and then press
ENTER (RM-AMU053) or
(RM-AMU054).
4Use the same procedure to set
the minutes.
The clock settings are lost when you
disconnect the power cord or if a
power failure occurs.

To display the clock when the

system is turned off

Press DISPLAY repeatedly until the clock
is displayed. The clock is displayed for a
few seconds.

Using the remote

When carrying the unit

Do the following procedure to protect
the disc mechanism.
Use the buttons on the unit for the
operation.
1Press "/1 to turn on the system.
2Press CD.
3Press Z OPEN/CLOSE to open
the disc tray and remove the
disc.
4Press Z OPEN/CLOSE again to
close the disc tray. Wait until
“CD NO DISC” appears in the
display.
5Hold down DISC SKIP/
EX-CHANGE and then press
"/1 until “STANDBY” appears
in the display. Then, “MECHA
LOCK” appears in the display.
6Unplug the AC power cord.