English
•This lamp is designed for use with the Sony projector.•Be sure to confirm that this lamp is usable with your projector before using it by reading the Operating Instruction or Installations Manual for Dealers supplied with your projector.
About lamp replacement
Attaching the lamp may cause fire or injury to persons.Users should ask a qualified Sony representative to attach the lamp.Replacing the lamp unit
Note•Before replacing the lamp unit, be sure to turn off the projector and disconnect the power cord of the projector. When replacing the lamp unit after using the projector, wait at least one hour to allow the lamp unit to cool.
•Whenever you replace the lamp unit, be sure to replace the air filter with a new one.
The illustrations below show the case of replacing the lamp unit with the projector installed on the ceiling.
1Loosen the two screws fixing the top panel at the rear of the projector using the supplied screwdriver (1), then slide the top cover backward and lift it to remove (2).
1
2
2Loosen the two screws fixing the lamp cover using the supplied screwdriver to remove the lamp cover.
4Holding the lamp unit with your hand, push back the stoppers on the left and right sides, then pull out the lamp unit.
5Insert the new lamp unit straight all the way in until it is securely in place, and pull out both the stoppers until you hear a click.
6Tighten the three screws loosen in step 3 to secure the lamp unit to the projector.
7Replace the lamp cover and tighten the two screws.8Replace the top panel and tighten the two screws.9Connect the power cord and set the projector to standby mode.10Press the RESET, <, ,, and ENTER buttons on the remote control in this order for less than five seconds each.
Specifications
| Dimensions | 180 ⋅ 157 ⋅ 163 mm |
| (7 1/8 ⋅ 6 1/4 ⋅ 6 1/2 inches) (w/h/d) |
| Mass | 1.8 kg (3 lb 15 oz) |
| Supplied accessories | Screwdriver (1) |
| Operating Instructions (1) |