5 Turn up the volume to a moderate level with the VOL control.

AMDR-RF960RK

Press the TUNE button briefly for automatic tuning of the headphones. If you do not receive a clear audio signal, press it again.

TUNE

TUNE

 

 

button

VOL control

BMDR-RF920RK

Tune the headphones into the frequency of the transmitter with the TUNE control until you can hear the audio signal loud and clear.

TUNE

TUNE control

VOL control

Follow steps 3 and 5 above until the receiving performance becomes better.

Bad reception conditions

If you use the unit near a cordless telephone, it may cause radio interference. If poor reception occurs, try another channel using the CHANNEL selector.

10GB

Sending RF signals from the Transmitter

The transmitter starts sending the RF signals automatically, when it detects audio signals from the equipment connected.

If it does not detect an audio signal for more than approximately 10 minutes, the transmitter will stop sending RF signals, and the power indicator turns off.

When the transmitter receives an audio signal again, it starts sending the RF signals, and the power indicator will light in red again.

If the audio signal is very weak, the transmitter does not send RF signals. If the transmitter is connected to a headphone jack, make sure the volume of the equipment connected is set to 5 – 6 or higher.

You may not hear the beginning of the sound from the headphones until the transmitter starts sending the RF signals after detecting an audio signal.

Note

If the transmitter is connected to the headphones jack of the source equipment, set the volume of that equipment as high as possible without distorting the audio signal.

The headphones automatically turn off when they are taken off

– Auto power on/off function

Do not pull up the self-adjusting band when not in use, as this will consume the battery power.

Notes

•If hiss is hear, move closer to the transmitter.

•You may hear some noise when you disconnect the AC power adaptor from the transmitter before taking off the headphones.

After listening to a program

Take the headphones off and rest them away on the transmitter, and recharge them.

Note

Do not hang the headphones by the self adjusting band, otherwise, the self adjusting band will be pulled up and the headphones will be switched on.