4 Press ENTER.

The station is stored.

5 Repeat steps 1 through 4 to store other stations.

To tune in a station with a weak signal

Press + or – (or TUNING +/– on the remote) repeatedly in step 2 to tune in the station manually.

To set another station to an existing preset number

Start over from step 1. After step 3, turn the shuttle until it clicks to select the preset number where you want to store the other station.

You can preset a new station in the selected preset number.

To erase a preset station

1Press and hold TUNER MEMORY until a preset number appears in the display.

VOLUME

ALL DISCS

ß￿

2Turn the shuttle until it clicks to select the preset number you want to erase.

Select “ALL ERASE” when you want to erase all the preset stations.

3Press ENTER.

“COMPLETE” appears in the display.

When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.

To change the AM tuning interval(Except for the European and Middle Eastern models)

The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To switch the AM tuning interval, tune in any AM station first, then turn off the power. While holding down TUNER/BAND, turn the power back on. When you switch the interval, AM preset stations are erased. To switch back to the original interval, repeat the same procedure.

Tip

The preset stations are retained for half a day even if you unplug the power cord or a power failure occurs.

11