Timer-recording radio Programs, 14GB, Program Edit

Tune in the preset radio station (see “Listening to the radio” on page 11).

Recording to a tape (continued)

Recording a CD by specifying track order

—Program Edit

You can record tracks from all the CDs in the order you want. When programing, make sure the playing times for each side do not exceed the length of one side of the tape.

1 Insert a recordable tape into deck B, then press CD.

2 Press PLAY MODE repeatedly until “PROGRAM” appears in the display.

3 Press one of the DISC 1–3 button to select a CD.

To program all the tracks on a CD at once, proceed to step 6 while “AL” appears in the display.

4 Press . or > repeatedly until the tracks you want appears in the display.

5 Press ENTER.

The track(s) is (are) programmed. The program step number appears, followed by the total playing time.

6 To program additional tracks, repeat steps 3 to 5.

Skip step 3 to select tracks from the same disc.

7 Press CD SYNC HI-DUB.

Deck B standby for recording. The REC

PAUSE/START indicator flashes.

8 Press DIRECTION repeatedly to select

gto record on one side. Select j (or RELAY) to record on both sides.

9 Press REC PAUSE/START.

Recording starts.

14GB

To	Do This
Cancel Program Edit	Press PLAY MODE
	repeatedly until “1 DISC” or
	“ALL DISCS” appears in
	the display.

Clear a track from	Press CLEAR on the remote
the end	when playback is stopped.

Tip

To check the required tape length for recording a CD, press EDIT after you have loaded a CD and pressed CD. The required tape length for the currently selected CD appears, followed by the total playing time for side A and side B respectively (Tape Select Edit).

Note

You cannot use Tape Select Edit for discs containing over 20 tracks.