Connecting the Net MD to your computer

After the software installation is completed, connect the Net MD to your computer. Refer to the operating instructions of the Net MD as well.

1 Make sure the remaining power of the dry battery is sufficient.

Note

Disconnect the dedicated USB cable before replacing the dry battery.

2 Insert a recordable disc into the Net MD.

3 Make the power source and the dedicated USB cable connections with the Net MD and the computer.

To the USB

To the USB jack/connecting terminal dedicated jack

Net MD

Computer

devices*

Dedicated

 

 

USB cable

*If a cradle is supplied with your Net MD, connect the dedicated USB cable to the USB cradle and place the Net MD onto the USB cradle.

4 Check the connections.

When the connections have been properly made, “PCppMD”* appears in the display of the Net MD.

*Depending on the device, “Net MD” may be displayed.

Notes

•When using the Net MD connected to your computer, make sure to run the recorder with a new dry battery. We do not assure the results should there be a mis-operation, check-out failure, or destruction of audio data caused by insufficient battery power.

•Place the recorder on a stable surface so that the dedicated USB cable does not become detached.

39