Advanced Settings
Setting a network manually
When it is necessary to set a network IP address or DNS address, follow the procedure below.
1Tap [Advanced Setup] in the lower right corner of the [Wireless LAN Setup] input screen.
2Tap the checkbox of [Auto] in [IP Address] or [DNS Address], and remove the tick.
The IP Address input screen or the DNS Address input screen appears.
3
4
Enter necessary addresses.
Tap [OK] when you complete the setting.
Disabling the power saving mode
1Tap [Advanced Setup] in the lower right corner of the [Wireless LAN Setup] input screen.
2Tap the checkbox of [Enable] in [PowerSaveMode], and remove the tick.
The power saving mode is disabled.
Tip
When the communication conditions are not good, you can disable the power saving mode to maximize the battery power and achieve better communications. However, it will make the battery life shorter.
Normally, the power saving mode is recommended.
20