14 Projecting an Image
Correcting for trapezoidal distortion of the projected image (Keystone
adjustment)
If the screen is tilted, or you are projecting from an oblique angle, perform keystone adjustment.
1Press the KEYSTONE key on the
Remote Commander once or select “V
Keystone” in the Installation menu to
display the adjustment menu.
2Adjust the value using V/v/B/b.
The higher the setting, the narrower the
top of the projected image. The lower
the setting, the narrower the bottom of
the projected image.
If the projected image is trapezoidally-distorted in the lateral plane (VPL-FH36/
FH31 only)
1Press the KEYSTONE key on the
Remote Commander twice, or select
“H Keystone” in the Installation menu
to display the adjustment menu.
2Adjust the value using V/v/B/b.
The higher the setting, the narrower the
right side of the projected image. The
lower the setting, the narrower the left
side of the projected image.
• Since the Keystone feature is electronic, image deterioration may occur.
• Depending on t he position adjusted with the lens shift feature, using the Keystone feature may
change the aspect ratio of the original image, or the projected image may be distorted.
• If keystone corr ection is performed using the KEYSTONE key, the Warp correction feature (if
enabled) will be canceled.
Increase setting
Decrease setting
Notes
Decrease setting Increase the setting