6
Installation Instructions Pitch-Adjustable Mount PLP91/D
MOUNT THE DISPLAY
Mount the display as follows:
1. Make sure no power is supplied to the display and the flag is in
the lowered (open) position before attempting to mount the dis-
play.
2. Using two people, slide the display down over the mount.
Make sure all four Q-buttons of the display engage all four
slots in the mount.
3. With the Q-buttons of the display fully engaged in the slots of
the mount, secure the display on the mount by raising the flag
all the way to their locked position. If the flag does not fully
engage, remove the display and make sure the brackets are
correctly installed.
NOTE: A security lock may be installed through the hole in the
locking flag for additional security (see Figure 6).
NOTE: If display does not remain at desired tilt setting, tighten
the nut and bolt on tilt arms on each side (see Figure 7).
WARNING: Make sure the flag securing the display is com-
pletely lowered at all times except when removing
or installing the display. The flag must be all the
way down when installing/removing cables.
Figure 7. Tilt Tension Adjustment
to adjust tilt tension
Loosen or tighten
this bolt
or lock in place
Figure 6. Optional Security
Security Lock May Be
Installed