Getting Started
Assembling the Turntable
1
1Place the rubber mat on the platter.
To make sure it operates properly, rotate the platter clockwise once or twice with your hand.
Notes on installation
•Place the turntable on a level surface.
•Avoid placing the unit near electrical appliances (such as a television, hair dryer, or fluorescent lamp) which may cause hum or noise.
•Place the turntable where it will not be subject to any vibration, such as from speakers, slamming of doors, etc.
•Keep the unit away from direct sunlight, extremes of temperature, and excessive dust and moisture.
Setting the Voltage Selector (Only on models supplied with a voltage selector)
Check that the voltage selector is set to the local power line voltage. If not, set the selector to the correct position using a screwdriver.
1Remove the dust cover.
2Remove the lid, and set the voltage selector to the local power line voltage using a screwdriver.
3Replace the lid and close the dust cover.
4