,There was a power failure during recording.
,The recorder’s internal clock stopped due to a power failure that lasted for more than 1 hour. Reset the clock (page 60).
,The channel was disabled after the timer recording was set. See “Channel Setting” on page 57.
,Disconnect the mains lead from the mains, and connect it again.
,“PDC/VPS Scan Off” was selected in the OPTIONS menu (page 38).
,The programme contains copy protection signals that restrict copying.
,Other timer setting overlapped the timer setting (page 43).
,There is no DVD inside the recorder.
,There is not enough disc space for the recording.
Recording does not stop immediately after you press x REC STOP.
,It will take a few seconds for the recorder to input disc data before recording can stop.
Recording does not stop after you press x.,Press x REC STOP.
Timer recording is not complete or did not start from the beginning.,There was a power failure during recording. If the power recovers when there is a timer recording, the recorder resumes recording. Should the power failure continue for more than 1 hour, reset the clock (page 60).
,Other timer setting overlapped the timer setting (page 43).
,Disc space was not enough.
,The PDC/VPS function is working.
Contents previously recorded were erased.,Data that is not playable on this recorder but was recorded on a DVD with a PC will be erased from the disc when the disc is inserted.
,Check that the clock and date are set correctly.
,Check that the PDC/VPS time you set is the correct one (there might be a mistake in the TV programme guide). If the broadcast you wanted to record did not send the good PDC/VPS information, the recorder will not start recording.
,If the reception is poor, the PDC/VPS signal might be altered and the recorder might not start recording.
,“PDC/VPS Scan Off” is selected (page 38).
Recording/editing is not possible.,
Nothing was recorded even though you set the
,You forgot to turn off the connected equipment. Turn off the connected equipment and set the recorder to Synchro- Rec standby mode (page 44).
,The recorder was not set to the Synchro- Recording standby mode. Press
c z SYNCHRO REC to have the recorder stand by for recording. Make sure the SYNCHRO REC indicator lights up on the front panel (page 44).
,The equipment is not connected to the LINE 3/DECODER jack of the recorder.
,The recorder is connected to the TV output jack of the connected equipment.
,The timer setting for the connected equipment overlapped the recorder’s timer setting (page 45).
,There was a power failure during the recording.
The recorder automatically starts recording when the satellite receiver is turned on.
,The
74