zIf programming is unsuccessful, check the following:

• If the program indicator does not light up in Step 1, the batteries are weak. Replace both batteries.

• If you do not do Step 2 within twenty seconds after pressing the IR SET button in Step 1, the remote automatically exits programming mode. Start again from Step 1.

Notes

•To redo a setting during programming, press IR SET to return to step 2.

•After Step 1, only the first function button that is pressed will register. If you press more than one function button, it will not register.

•In step 3, only the first three numbers entered are valid.

•If you enter an unidentified preset number, the program indicator goes off without flashing after pressing ENTER D.TUNING in step 4, then the remote exits programming mode. The previously programmed settings are memorized.

Clearing all programmed signals

To clear all the programmed signals, do the following procedure. The remote is reset to its factory-setting.

First press down MASTER VOLUME –, then AV ?/1, and then ?/1 until the program indicator flashes three times, then goes off.

The numeric codes corresponding to the component and the maker of the component

Use the numeric codes in the tables below to control non- Sony conponents and also Sony components that the remote is normally unable to control. Since the remote signal that a component accepts differs depending on the model and year of the component, more than one numeric code may be assigned to a component. If you fail to program your remote using one of the codes, try using other codes.

Notes

•The numeric codes are based on the latest information available for each brand. There is a chance, however, that your component will not respond to some or all of the codes.

•All of the functions on this remote may not be available when used with your particular component.

Operations Remote Advanced

13