To cancel programming
Press USE MODE during any step. The remote automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3, press VIDEO 1, then MACRO1 or MACRO2. This allows you to specify 1 second delay before output the next IR code. Be sure not to press MACRO1 or MACRO2 for more than 2 seconds.
To clear the programmed IR codes
Clear each macro step individually.
1 Press MACRO1 or MACRO2 (in which the IR code you want to clear is programmed) while pressing down USE MODE.
2
3
4 Hold down MACRO1 or MACRO2 for more than 2 seconds.
The IR code is cleared. The indicator lights twice slowly, then the remote automatically exits the macro setting mode.
To start macro play
Press MACRO1 (or MACRO2).
Note
If the Macro Play function does not work properly, program a delay between each operation. See “To delay the output of an IR code”.
Selecting the mode of the
remote
Set the remote mode using the USE MODE button (wk) and the remote mode buttons (2).
Selecting the command mode
You can switch the command mode (AV1 or AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
Press 1 (AV1) (or 2 (AV2)) while pressing down USE MODE.
The indicator lights once (twice for AV2), then the command mode switches.
Setting to the 2nd room mode.
You can use the remote to select the function for the 2nd room (2nd room mode). You can use the function buttons only for the 2nd room.
Press 2ND ROOM while pressing down
USE MODE.
The indicator lights for a while, then the mode switches to the 2nd room mode.
Tips
•If you press a function button while pressing down 2ND ROOM, you can select the function for the 2nd room even though the mode is not set to the 2nd room mode.
•If you press 2ND ROOM only, you can output the source signal of the current function of the receiver to the amplifier in the 2nd room.
Setting to the 3rd room mode.
You can use the remote to select the function for the 3rd room and adjust the volume in the 3rd room (3rd room mode). During 3rd room mode, you can adjust the volume of speakers in another room when you set the receiver to output the sound using SPEAKER terminals. You can use the function buttons and MASTER VOL +/– buttons only.
Press 3 (3RD) while pressing down USE MODE.
The indicator lights 3 times, then the mode switches to the 3rd room mode.
To check the mode of the remote
Press USE MDOE. You can check the remote by the indicator.
Mode | Indicator lights |
AV1 | once |
|
|
AV2 | twice |
|
|
2nd room | once (for a while) |
|
|
3rd room | 3 times |
|
|
Operations Remote Advanced
15