Rear Panel Parts Descriptions
Parts of Functions and Location
| LINE OUT (ANALOG) |
| BALANCED | COMMAND | DIGITAL OUT |
R | BALANCED | L | OUT | MODE | CD |
|
| COAXIAL | |||
|
|
|
|
| |
| 1:GROUND |
|
|
| ~AC IN |
|
| ON | CD1 | STANDARD | |
| 2:HOT (+) |
| |||
|
| OFF | CD2 | CUSTOM | |
| 3:COLD ( ) |
| |||
|
|
|
| TA - E1 / N1 | |
|
|
|
|
| |
R | UNBALANCED | L |
|
| OPTICAL |
1LINE OUT (ANALOG) UNBALANCED jacks (5)
Connect to an audio component using the audio connecting cord.
2LINE OUT (ANALOG) BALANCED connectors (5)
Connect to an audio component using the XLR (balanced) cord.
3BALANCED OUT ON/OFF switch (5)
Set to ON when the audio component is connected to the LINE OUT BALANCED connectors. In case of another connection, set it to OFF.
4COMMAND MODE selector
Normally set to CD1. When you connect a Sony CD player other than this player, set to CD2. In this case, you can control both the other Sony CD player and this player with CD1/CD2 on the remote. Set to CD1 to control the other Sony CD player, or CD2 to control this player.
5Switches depending on amplifier to be connected. For details, see “About the Switch Marked “STANDARD” on the rear panel of the player” on page 6.
6DIGITAL OUT (CD) OPTICAL connector (5)
Connect to an audio component using an optical digital cable.
7DIGITAL OUT (CD) COAXIAL connector (5)
Connect to an audio component using the coaxial digital cable.
Note
Only the audio signals of the CD can be output from the DIGITAL OUT connectors shown in 6 and 7. Those of the Super Audio CD cannot be output through DIGITAL OUT.