Trouble symptoms and remedies

If a problem is caused by the connected computer or other equipment, please refer to the connected equipment’s instruction manual. Use the self-diagnosis function (page 21) if the following recommendations do not resolve the problem.

Symptom

Check these items

No picture

If the 1 (power) indicator is not lit, or if the 1 (power) indicator will not light up when the 1 (power) switch is pressed

•Check that the power cord is properly connected.

•Check that the 1 (power) switch is in the “on” position.

If the 1 (power) indicator is green

• Use the self-diagnostics function (page 21).

or flashing orange

 

 

 

If CABLE DISCONNECTED

• Check that the video signal cable is properly connected and all plugs are firmly seated in

appears on the screen

their sockets (page 7).

 

• Check that the video input connector’s pins are not bent or pushed in.

 

• A non-supplied video signal cable is connected. If you connect a non-supplied video

 

signal cable, CABLE DISCONNECTED may appear on the screen before entering the

 

power saving mode. This is not a malfunction.

If NO INPUT SIGNAL appears on the screen, or the 1 (power) indicator is either orange or alternating between green and orange

•Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 7).

•Check that the video input connector’s pins are not bent or pushed in.

xProblems caused by the connected computer or other equipment

•The computer is in the power saving mode. Try pressing any key on the keyboard or moving the mouse.

•Check that your graphic board is attached to the computer properly.

•Check that the computer’s power is “on.”

GB

If OUT OF SCAN RANGE appears xProblems caused by the connected computer or other equipment

on the screen• Check that the video frequency range is within that specified for the monitor. If you replaced an old monitor with this monitor, reconnect the old monitor and adjust the

frequency range to the following:

Horizontal: 28 – 60 kHz (SDM-S51), 28 – 92 kHz (SDM-S71/S81)

Vertical frequency: 48 – 75 Hz (SDM-S51), 48 – 85 Hz (SDM-S71/S81)

If using Windows

• If you replaced an old monitor with this monitor, reconnect the old monitor and do the

 

following. Select “SONY” from the “Manufactures” list and select “SDM-S51” or “SDM-

 

S71”or “SDM-S81” from the “Models” list in the Windows device selection screen. If

 

“SDM-S51” or “SDM-S71”or “SDM-S81” does not appear in the “Models” list, try “Plug

 

& Play” or install the information file for this monitor using the Windows Monitor

 

Information Disk (page 9).

 

 

If using a Macintosh system

• If you use the Macintosh adapter (not supplied), check that the Macintosh adapter and the

 

video signal cable are properly connected (page 7).

Picture flickers, bounces, oscillates, or is scrambled

•Adjust the pitch and phase (page 13).

•Try plugging the monitor into a different AC outlet, preferably on a different circuit.

•Change the orientation of the display.

xProblems caused by the connected computer or other equipment

•Check your graphics board manual for the proper monitor setting.

•Confirm that the graphics mode (VESA, Macintosh 19" Color, etc.) and the frequency of the input signal are supported by this monitor (Appendix). Even if the frequency is within the proper range, some graphic boards may have a sync pulse that is too narrow for the monitor to sync correctly.

•Adjust the computer’s refresh rate (vertical frequency) to obtain the best possible picture.

(continued)

19