Sony SLV-XA147PS, SLV-XF247PS Setting up the remote commander, Press, Notes, VOL +/–, TV/VIDEO, ; (TV power), (on/standby), Remote sensor, Inserting the batteries

Step 2

Setting up the remote commander

Inserting the batteries

Insert two R6 (size AA) batteries by matching the + and – on the batteries to the diagram inside the battery compartment.

Insert the negative (–) end first, then push in and down until the positive (+) end clicks into position.

Using the remote commander	Remote sensor
You can use this remote
commander to operate the unit
and a Sony TV. To operate this
unit, point at the remote sensor
on the unit. To operate the TV,
point at the remote sensor on
the TV.	TV/VIDEO
	; (TV power)
	u
	(on/standby)
	PROG (CH) +/–
	VOL +/–
To	Press
Turn the TV to standby or active mode	u(on/standby)
Turn on the TV power	;(TV power)
Increase (+) or decrease (–) the TV volume	VOL +/–
Change the TV programme position	PROG (CH) +/–

Select an input source of the TV either from aerial in or from line in TV/VIDEO

Notes

•With normal use, the batteries should last about three to six months.

•If you do not use the remote commander for an extended period of time, remove the batteries to avoid possible damage from battery leakage.

•Do not use a new battery with an old one.

•Do not mix different types of batteries.

Started Getting

Getting Started 5