No sound or only a very
/Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/Select a sound field from the CINEMA or VIRTUAL 3D genres (except MONO MOVIE and STEREO MOVIE) (see page 28).
/Adjust the speaker volume (see page 18).
/Make sure the rear speaker size parameter is set to either SMALL or LARGE (see page 15).
Recording cannot be done.
/Check that the components are connected correctly.
/Select the source component by rotating the FUNCTION control.
/When recording from a digital component, make sure the input mode is set to ANALOG (see page
23)before recording with a component connected to the analog MD/DAT or TAPE terminals.
/When recording from a digital component, make sure the input mode is set to DIGITAL (see page
23)before recording with the component connected to the DIGITAL MD/DAT OUT terminals.
Radio stations cannot be tuned in.
/Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
/The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
/Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning) (see pages 38 and 47).
/No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (see page 39).
/Press DISPLAY so that the frequency appears in the display.
The surround effect cannot be obtained.
/Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/Make sure that the SPEAKERS selector is set to A or B (not A+B) if you connected two sets of front speakers.
No picture or an unclear picture appears on the TV screen or monitor.
/Select the appropriate function on the receiver.
/Set your TV to the appropriate input mode.
/Move your TV away from the audio components.
The video image on the TV screen or monitor does not correspond to the selected component.
/Check the source of the video signal by pressing MODE repeatedly to display “V:XXX”. Then rotate FUNCTION to select the appropriate video source (if necessary).
The remote does not function.
/Point the remote at the remote sensor gon the receiver.
/Remove any obstacles in the path between the remote and the receiver.
/Replace all batteries in the remote with new ones, if they are weak.
/Make sure you select the correct function on the remote.
/If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component.
Reference sections for clearing the
receiver’s memory
To clear | See |
All memorized settings | page 19 |
|
|
Customized sound fields | page 35 |
|
|
Information Additional
45