Step 2: Adjust the position of the arm bases
(For the1 | Arm base B |
| |
| Arm |
| 2 |
| Arm base B |
| 2 |
Arm base A | 1 |
| |
| 1 |
Arm base A | |
| Tilt adjuster |
| Arm base B |
| 4 |
3 | Arm |
| Arm base B |
| 3 |
| 4 |
5 |
|
Arm base A | 5 |
| |
| 3 |
Arm base A | Tilt adjuster |
If you are going to install a KDL32XBR950 or a KLV30XBR900, skip Step 2 and go to Step 3.
1Remove the four (two for each arm bases) tilt adjusters .
2Remove the four screws that secure the arm bases to the Plate Unit.
3Remove the arm bases Aand put them in the slots facing inward. Put both arms
and the arm bases Bon the arm bases A.
4Secure the arm bases to the Plate Unit using the four screws removed in 2.
5Secure the arms to the arm bases using the four tilt adjusters removed in 1.
Notes
•If you are installing a display other than the
•When using an electric screwdriver to tighten the screws, the torque must be approx. 2 N•m.
Step 3: Decide on the location for installation
1 Unit: mm (inches)
300
100 (3 15⁄16)
)16
13/ (11
100 (3 15⁄16)
Leave spaces around the display. At least the amount of space shown in the diagram should be left between the display and a ceiling or raised portions of the wall.
Tip
Refer to the table (9 (US)) for the display installation dimensions.
100
)16
15⁄ (3
8 (US)