Recommended DIP switch settings:

Setup

Connecting the Printer

Connect the Thermal Receipt Printer to the UP-CR20L’s RS-232C connector with an RS-232C cable.

SW1

1-1

OFF

 

 

1-2

OFF

 

 

1-3

ON

 

 

1-4

OFF

 

 

1-5

OFF

 

 

1-6

OFF

 

 

1-7

ON

 

 

1-8

ON

 

 

SW2

2-1

OFF

 

 

2-2

OFF

 

 

2-3

OFF

 

 

2-4

OFF

 

 

2-5

OFF

 

 

2-6

OFF

 

 

2-7

OFF

 

 

2-8

OFF

 

 

TM-T88 III/TM-T88 IV

Thermal Receipt Printer

RS-232C cable

Cable to use: RS-232C cross (reverse) cable

(9-pin D-sub female - 25-pin D-sub male)

Setting Up the Thermal Receipt Printer

Set the DIP switch on the Thermal Receipt Printer according to the following chart. For details on how to set the DIP switch, refer to the operating instructions for the Thermal Receipt Printer.

Baud rate

38,400 bps

 

 

Handshake

XON/XOFF protocol

 

 

Data length

8 bits

 

 

Parity check

None

 

 

Preparing Image Data

Perform the following steps to prepare image data.

1 Create the image data on your computer.

2 Copy the image data onto an expansion CompactFlash card.

The following gives detailed information on the above steps.

Creating Image Data on Your Computer

Create the image data according to the following specifications.

Specifications for job ticket images Image size: 360(H) × 2 to 360(V) pixels Format: 24-bit Windows BMP

File storage location: \Sony\UPCR20\Ticket

Data file name for upper image: Logo.bmp Data file name for lower image:

A combination of letters and numbers that indicate the print type and print size are used for file names. Name the data files as follows.

When creating an image for the initial fee, name the data file “INIT_FEE.bmp”.

Example: P_3x5.bmp

A B

ALetters that indicate print types

Print type

Finish

Letters

 

 

 

Select & Print

Glossy

P

 

 

 

 

ProMatte

PM

 

 

 

Index print

Glossy

I

 

 

 

 

ProMatte

IM

 

 

 

Split image

Glossy

S

 

 

 

 

ProMatte

SM

 

 

 

Setup 4