20 Projecting
Projecting
1Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2Press the ?/1 key.
The ON/STANDBY indicator flashes in
green, and then lights in green.
3Turn on the equipment connected to
the projector.
4Press the INPUT key to select the
input source.
You can select directly the input signal
you want to project by pressing one key
from among INPUT A, B, C, D or E on
the Remote Commander.
Each time you press the INPUT key on
the control panel, the input signal
switches as follows:
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
• If “Auto Input Search” is set to “On,” the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
COMMAND
INPUT
AINPUT
BINPUT
C
INPUT
D
VIDEO
ENTER
MENU APA
RESET
SHIFTZOOMFOCUS
ASPECT
KEY
STONE
S VIDEO
INPUT
EAIR
SHOT
OFF ON
7
82
1
2
4
6,7,8
8
78
4
6,7,8
8
Rear remote control
detector
To input from Press INPUT
to display
Computer, etc.
connected to the
INPUTA connector
Input-A
Computer, etc.
connected to the
INPUT B connector
Input-B
Computer/VCR, etc.
connected to INPUT C
connector
Input-C
Computer/VCR, etc.
connected to INPUT D
(Digital) connector
Input-D
Computer connected to
LAN to use the network
presentation function
Input-E
Video equipment
connected to the VIDEO
input connector
Video
Video equipment
connected to the
SVIDE O input
connector
S-Video
Notes
Input-A
t
Input-B
t
Input-C
t
Input-D
t
Input-E
S-VideoTVideoT