Check that the ON/STANDBY indicator lights in red.

9Point the remote control at the projector and press the following buttons on the remote control in the following order for less than five seconds each: RESET, <, ,, ENTER.

Notes

•Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

•Be sure to use the LMP-H130 Projector Lamp for replacement. If you use lamps other than LMP-H130, the projector may cause a malfunction.

•Be sure to turn off the projector and unplug the power cord before replacing the lamp.

•The projector will not turn on unless the lamp is securely installed in place.

•The projector will not turn on unless the lamp cover is securely closed.

•To erase the message displayed on the screen, press any button on the remote control or the control panel.

Disposal of the used lamp

For the customers in the USA

This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or Electronics Industries Alliance (http://www.eiae.org).

Replacing the Air Filter

The air filter should be replaced periodically. When “Please replace the filter.” appears on the screen, replace the air filter immediately.

Notes

•Replacing the air filter is very important to maintain the high efficiency of the projector and to prevent a malfunction. When the replacement message appears on the screen, replace the air filter without delay. It is recommended to replace the air filter approximately every 1000 hours of use.

•When removing the air filter from the projector, be careful that no dust or object gets into the inside of the projector.

1Turn off the projector, then unplug the AC power cord.

2Open the filter cover toward you, while pushing the three filter lock knobs upward.

3Remove the air filter from the projector by holding the tab on the filter.

Others

Replacing the Air Filter 49