12 Projecting an Image
Changing the aspect ratio of the projected image
Press ASPECT on the remote commander to change th e aspect ratio of the projected image.
You can also change the setting in Aspect of The Screen Menu (page 16, page 17).
Correcting trapezoidal distortion of the projected image (Keystone feature)
Keystone feature may not work automatically when the screen is tilted. In this case, set
keystone manually.
1Press KEYSTONE on the remote
commander or select V Keystone in The
Installation Menu.
2Use V/v/B/b to set the value. The higher
the setting, narrower the top of the
projected image. The lower the setting, the
narrower the bottom.
Since the Keystone adjustment is an electronic
correction, the image may be deteriorated.
Displaying a pattern for adjusting an image
You can display a pattern for adjusting the projected image with the PATTERN key on the
Remote Commander. Press the PATTERN key again to restore the previous image.
Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment)).
Press APA on the remote commander. Press again to cancel during the setting. You can also set
APA in The Screen Menu (page16).
If Smart APA is set to On, executes APA automatically when a signal is input (page18).
Note
Increase the number
towards plus
Increase the number
towards minus