Changing the operative direction

The operative direction of controls is factory-set as shown below.

To increase

To decrease

If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction.

Press (SEL) for 2 seconds while pushing the VOL control.

Adjusting the balance and fader

You can adjust the balance and fader.

1 Press (SEL) repeatedly until “BAL” or “FAD” appears.

Each time you press (SEL), the item changes as follows:

LOW* t MID* t HI* t

BAL (left-right) t FAD (front-rear)

*When EQ3 is activated (page 14).

2 Press the volume +/– button to adjust the selected item.

Note

Adjust within 3 seconds after selecting the item.

Quickly attenuating the sound

Press (ATT).

The “ATT” appears in the display.

To restore the previous volume level, press (ATT) again.

Canceling the beep sound

Press (6) while pressing (SEL) down.

To activate the beep sound again, press these buttons again.

Note

If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

13