Packaged in a standard 19" EIA format and occupying 1U (44,45 mm) of rack space, the TRANSIENT DESIGNER can be installed in a standard rack, but it is recommended that the rear of the case be supported, especially in touring applications. The TRANSIENT DESIGNER should not be installed near units which produce strong magnetic fields or extreme heat. Do not install the TRANSIENT DESIGNER directly above or below power amplifiers or digital processors. If possible, the TRANSIENT DESIGNER should be placed in an 'analogue rack' where the majority (or all) of the equipment installed is analogue. Check that the voltage details quoted on the back panel are the same as your local mains electricity supply.
•Use a small, flat bladed screwdriver to set the voltage selector to the voltage for the area in which the unit will be used.
•Never cover up the ventilation slots on the top side of the unit.
•If, during operation, the sound is interrupted or indicators no longer illuminate, or if abnormal odour or smoke is detected, or if liquids are spilled on the unit, immediately disconnect the power cord plug and contact your dealer.
•Only clean your TRANSIENT DESIGNER with a soft,
Transient Designer
Operation Safety
Important security advices
5
