Rear Connectors, Line Input 1/4 TRS Jack | SoundCraft 1GB2 instruction

Rear Connectors

INSERT (1/4" TRS Jack)

Tip	Send Signal
Ring	Return Signal
Sleeve Ground
LINE INPUT (1/4" TRS Jack)
Tip	Signal Hot
Ring	Signal Cold
Sleeve Ground
MIC INPUT (3 pin female XLR)
Pin 1	Ground
Pin 2	Signal Hot
Pin 3	Signal Cold
DIRECT OUTPUT (1/4" TRS Jack)“
Tip	Signal Hot
Ring	Signal Cold

Sleeve Ground

The DIRECT OUTPUT is normally post fader. Pressing the PRE button switches it to pre-insert- point.

GB2 User Guide

25

Image 26

SoundCraft 1GB2 manual Rear Connectors, Line Input 1/4 TRS Jack

Contents

Page GB2 User Guide GB2 User Guide GB2 User Guide Contents GB2 User Guide Introduction Key Features Warranty GB2 User Guide Installation Safety Symbol Guide Important Safety Warnings GB2 User Guide Power Cable Mains InstallationGeneral Precautions General Wiring Procedures Shielding Initial Wiring ConsiderationsAudio Wiring Points to Remember Recommended headphone impedance is 50-600 ohms Initial set-up Setting Up & TroubleshootingTroubleshooting Optional External Power Supply Meters not showing any signal Audio Connector Pinouts Dimensions Block Diagrams Input Channels Master Section / Outputs GB2 User Guide Using The Console Mono Input Rear Connectors Line Input 1/4 TRS Jack EQ is switched in by the EQ switch Stereo Input MIC Input Left and Right 3 pin female XLR GB2 User Guide Master Section Mix L, R and Mono Outputs Talkback Record OutputsMonitoring & PFL/AFL PSU Monitor LEDs Rear Connector Panel Front Panel Connectors Lamps Typical Specifications Noise Mark Up Sheets GB2 User Guide GB2 User Guide