( INSTALLATION STEP 1 |
| INSTALLATION STEP 2 ) | ||
|
|
|
|
|
SELECTING THE SPEAKER OUTPUT MODE | WIRING |
| POWER AND GROUND |
Channels 1 through 4 of the RUBICON & 805 amplifiers have the ability to | To ensure mlaximum output from your RUBICON amplifier, use high quality, low- |
operate in any one of the following modes: | loss power and ground cables and connections. The RUBICON amplifiers will |
| accept up to 4 gauge power and ground cables. Determine from the chart below |
Stereo (STACT/Mxed Mono).= Use this mode for either stereo operation (left | the minimum gauge power and ground wire for your application. |
and right channels) or for Mixed Mono operation. |
|
|
|
| |
I | up to 10’ | up to 20’ | |||
| |||||
|
|
| |||
Bridged Mono: Use this mode to get a bridged mono output while using only |
|
|
|
| |
| RUBICON405 | 4or8gauge | 4 gauge only | ||
the right channel input for 3 channel operation. |
| ||||
|
|
|
| ||
Please follow the wiring schemes below for the correct operation: |
| RUBICON | 4 or 8 gauge | 4 gauge only | |
|
|
|
|
MONO /’
‘\ \ | / ,/” |
BRIDGED MONO
- L+
’a*
t. +?
1
I
‘ST ,’
MIXED MONO
- L+ - R +
I
12
S T , ,
‘.
‘\/
STEREO
- L+
CIRCUIT BREAKERS AND FUSES
EXTERhlALLike all audio components, the RUBICON amplifier must be fused near the battery. A fuse or circuit breaker must be located within 18” of the batters. This will prevent a fire in the event of a shorted cable. See the chart below to determine the correct fuse value.
INTERNALThe RUBICON amplifier is fused with two
replace the fuse with a higher value than what is supplied. This may result in amplifier damage and will void the warranty!
RUBICON405 & 805 Amplifier Fuse Values
| Amp/tier Fuse | Battery Fuse / Circuit Breaker |
|
|
|
RUBICON405 | (2) 20 amp a&motive | mamp |
|
|
|
RUBICON805 | 60 amp | mamp |
|
|
|
REMOTE TURN-ON
Connect the “Remote” line to the
SIGNAL CABLE
Use a high quality cable that will be easy to install and has minimal signal loss to guarantee optimum performance.
SPEAKER CABLE
The RUBICON amplifiers will accept up to 8 gauge speaker cable. Use a high quality, flexible,
13