INSTALLATION STEP 3 )
WIRING
POWER AND GROUND
To ensure maximum output from your RUBICON amplifier, use high quality, low- loss power and ground cables and connections. The RUBICON amplifiers will accept up to 4 gauge power and ground cables. Determine from the chart below the minimum gauge power and ground wire for your application.
I | up to 10’ | up to 20’ |
| |
RUB/CON Class A 5.2 | 4 or 8 gauge | 4 gauge only | I | |
|
|
|
| |
RUB/CON Class A 10.2 | 4 gauge only | 4 gauge only |
| |
|
|
|
|
|
CIRCUIT BREAKERS AND FUSES
EXTERNALLike all audio components, the RUBICON amplifiers must be fused near the battery. A fuse or circuit breaker must be located within 18” of the battery. This will prevent a fire in the event of a shorted cable. See the chart below to determine the correct fuse value.
INTERNALThe RUBICON amplifiers are fused with an
RUB/CON Amplifier Fuse Values
|
|
|
| Amplifier Fuse |
| Battery Fuse / | Circuit |
|
|
|
|
|
| Breaker |
|
| |
wss A 5.2 |
|
|
|
|
|
| ||
1 |
| 60 amp | 1 | 80 amp |
| I | ||
|
|
|
|
|
|
| I | |
RUB/CON Class A 10.2 | [ | 80 amp | I | 100 amp |
|
SAMPLE WIRING DIAGRAM
INSTALLATION STEP 4 )
AMPLIFIER LOCATION
The RUBICON amplifiers employ highly efficient circuitry, a
When mounting the amplifier, it should be securely mounted to either a panel in the vehicle or an amp board or rack that is securely mounted to the vehicle. The mounting location should be either in the passenger compartment or in the trunk of the vehicle, away from moisture, stray or moving objects, and major electrical components. To provide adequate ventilation, mount the amplifier so that there are at least two inches of freely circulating air above and to the sides of it.
MOUNTING THE AMPLIFIER
a.Using the amplifier as a template, mark the holes on the mounting surface.
b.Remove the amplifier and drill the holes for the mounting screws.
C.Secure the amplifier to the mounting surface using the supplied hardware.
WIRING
a.Run and connect the audio signal and remote
b.Carefully run the positive cable from the amplifier to a fuse or circuit breaker within 18” of the battery.
C.Connect the fuse or circuit breaker lead to the battery. Leave the circuit breaker off or the fuse out until everything is bolted down.
d.Secure the ground cable to a solid chassis ground on the vehicle. It may be necessary to sand paint down to raw metal for a good connection.
e.Double check each and every connection1
f.
POWER UP
Power up the system, there may be a
13