Installation
Before installing any audio equipment, it is good practice to disconnect the ground terminal on the battery to avoid dam- age to the vehicle or audio equipment. Failure to do this means you’re a few brews short of a
Factory ground wire may need to be upgraded, espe- cially if it is smaller than the power wire, frayed, or broken.
Run signal cables (RCA) and remote
Avoid sharp edges
that could chafe
through the insulation.
Positive battery terminal
Fuse must be
installed within 18” of battery.
Drill a hole in the firewall & use a rubber grommet to keep wire from shorting.
Run the cables under the carpet near the side of the vehicle. Be careful not to drill or screw into the wires when replacing trim.
Ground cable to
bare metal chassis/
frame with nut & bolt. No screws or seat/seatbelt bolts!
7
