INSTALLING THESPL6 MIDRANGE/ WOOFER
The SPL 6 Midrange/Woofer can be mounted on the front or rear of a panel; gaskets are provided for both options. The bolt hole configuration will fit a variety of American, European and Asian OEM patterns making it ideal for direct placement. Best performance is achieved when the speaker is securely mounted to a door panel or rear deck. There should be no gaps between the speaker and the mounting surface, as this will impair its low frequency performance. Be certain that both the panel and the speaker are securely mounted to prevent unwanted vibration.
1)Mark the speaker location by using the template provided.
2)Cut the opening and debur the edges with a file.
3)Hold the speaker in place against the mounting surface and mark the mounting bolt holes.
6)Drill the appropriate size hole for the screws provided.
7)Place the SPL 6 into the trim ring, make the speaker wire connections, then install the speaker/trim ring assembly to the panel using
MOUNTING THE SPL 6X CROSSOVER
The SPL 6X Passive Crossover can be mounted in virtually any location inside the vehicle. Be sure not to mount the SPL 6X outside the vehicle, or in a location where it may be exposed to dirt or moisture (e.g., the engine compartment, inside a wheel housing, at the bottom of a leaky trunk, inside a door).
6
60.pub | Friday, September 10, 1999 21:03 |
page 6 |
|
