5
English
Colour frame holder
The colour frame holder is equipped with a spring-loaded retaining clip that prevents colour frames
and accessories from falling out. See Figure 2.
Step 1: Release the retaining clip by pushing it sideways while gently pulling backwards.
Step 2: Insert the colour frame.
Step 3: Lock the retaining clip by pushing sideways while gently pushing forward.
For maximum gel life with specific lens tubes, refer to the tables below.
WARNING:
Make sure all colour frame accessories are locked in position with the
retaining clip before hanging the Source Four luminaire.
Note:
The performance of saturated colours may be less than desirable in any theatrical
lighting luminaire, especially when equipped with a 750w lamp. For best results,
always use high-quality colour media rated for high-temperature use.
ETC’s optional Conical Gel Extender, part # 7060A1048, will provide maximum
colour media life. For 14° lens tubes, use part # PSF1029. Gel Extenders are not
recommended for 70° and 90° lens tubes due to the extremely wide-angle beam.
A variety of heat shield products is also available from many colour media
manufacturers. Follow the manufacturer’s instructions for the use of these
products.
Lens Tube Soft Focus Back
(Lamp “flat”)
Sharp Focus
(Lamp “cosine”)
Soft Focus Forward
(Lamp “peak”)
Soft Focus Forward
(Lamp “cosine”)
14° worse good best good
70° best good worse good
90° best good good worse
19° worse better better not applicable
26° worse better better not applicable
36° better better worse not applicable
50° worse better better not applicable
ED Lens Tube Soft Focus Back
(Lamp “flat”
Sharp Focus
(Lamp “cosine”)
Soft Focus Forward
(Lamp “peak”)
Soft Focus Forward
(Lamp “cosine”)
19° worse better better not applicable
26° better better worse not applicable
36° better better worse not applicable
50° better better worse not applicable
Figure 2
Retaining clip in the
locked position