SpectraLink Corporation | LinkPlus Interface Guide |
| Siemens ROLM PBX System |
3.Interface Implementation
This section describes the recommended programming to use the Wireless Telephone System with Siemens Rolm systems. The procedures assume:
•The Rolm 8000, 9000, 9200, 9751, or 9006, or a Siemens Hicom 300E is installed and operational in an approved configuration. See the Telephone Switch Interface Matrix document for tested configurations.
•A trained Rolm technician or system administrator will be on site with the Installer to program the system.
•The Link WTS or NetLink Telephony Gateway is installed and the handsets are available for programming.
3.1Set the Switch Interface Type
Link 150 MCU
The Link 150 Master Control Unit requires the switch interface type to be configured using the front panel buttons. The configuration procedures are detailed in Link 150 M3 MCU: Installation and Operation.
Link 3000 MCU
When configuring the Link 3000 MCU, the PBX interfaces are available as
NetLink Telephony Gateways
Connect to the NetLink Telephony Gateway using the serial or modem interface. From the Main Menu, choose Gateway Configuration. Scroll to Telephone Switch Type and press enter to change this field, from the Submenu of PBX types, select Siemens Rolm. Refer to NetLink Telephony Gateway: Installation, Configuration, and Administration for details on configuring the Telephone Switch Type.
Part Number: | Page 10 |