SECTION IV

Preventive Maintenance Instructions

DAILY

1.Make certain drying cycle has ended.

2.Open loading door.

3.Unlock and remove lint panel.

4.Remove accumulated lint in lint compartment. Lint left in lint compartment will be drawn back onto lint screen and restrict air circulation.

5.Clean lint from lint screen. If lint screen is torn replace immediately. A torn lint screen allows lint to flow into ductwork system restricting air circulation.

6.Ensure lint screen covers entire opening in lint screen hood. Gaps between lint screen and lint screen hood allows lint to flow into ductwork system restricting air circulation.

7.Wipe any accumulated lint off thermostat

sensing probe. Lint buildup on sensing probe will cause overheating of tumbler.

8.Replace and securely lock lint panel.

WARNING

THERMOSTAT

SENSING PROBE

LINT

SCREEN

T046IE3A

Figure 34

MONTHLY

1.Perform daily cleaning of accumulated lint.

2.Deactivate electrical circuit by turning off electrical disconnect switch on rear of tumbler.

4.Remove exhaust duct from rear of tumbler and clean out all accumulated lint.

5.Reinstall exhaust duct.

6.Remove bottom cover from vertical exhaust duct and clean out all accumulated lint.

7.Reinstall vertical exhaust duct cover.

8.Inspect entire duct work assembly and clean out all accumulated lint.

9.Energize electrical circuit to tumbler by turning on electrical disconnect switch on rear of tumbler.

M412616

57