Spirit 110 | Corded Telephone |
2. | Installation |
2. | Installation |
3. Telephone Operation
Unpacking your phone
In the box you will find:
•Base Unit
•Handset
•Coiled Handset cord
•Telephone line cord for Base unit
•User manual
1. Locating the Base unit |
The Base unit should be placed on a level surface, in a position where: |
the telephone line cable will reach your telephone line socket or |
extension socket. |
it is not close to a sink, bath or shower, or anywhere else where |
it might get wet. |
it is not close to other electrical equipment - fridges, washing |
machines, microwave ovens, TVs, fluorescent lights, etc. |
Making a 1 call
2
3
To answer a call
Lift the Handset, listen for a dial tone.
Dial the telephone number you wish to call.
To end the call, return the Handset to the Base unit.
Lift the handset to answer call.
Keep the packing materials in a safe place in case you later need to transport the unit.
Keep your sales (till) receipt, which is your guarantee.
2.Plug the coiled handset cord into the Handset. Plug the other end into the jack on the left side of the Base unit.
3.Place the Handset in the Base unit.
Make sure the plugs click into place. 
To end a call
Last Number 1
Redial
2
Replace the Handset on the Base unit cradle.
Lift the Handset to redial the last number.
Press LNR button.
ÖThe phone automatically dials the last number you called (maximum of 32 digits).
1. Where to find it
1
2
3
4
5
6
to Modular Wall jack
Always use the telephone line cord supplied with your Spirit 110 phone. Other telephone line cords may not work.
Mute
Function
2
Use on PBX
During a call press and hold the | (MUTE) |
button. |
|
ÖWhen the mouthpiece is muted, the person at the other end of the call cannot hear you but you can hear his side.
To get back to the call, release the (MUTE) button.
If you are using your Spirit 110 phone on a PBX,and the PBX user guide tells you to press
RECALL;
Press R (RECALL) button on your
Spirit 110 phone.
7
8
1.Ringer light - This flashes when the phone is ringing for an incoming call.
2.M1,M2 and M3 one
3.STO (Store)button
4.MEM button
5.LNR(Last Number Redial) button
6.Mute button
7.R(Recall) button
8.P(Pause) button
4.Plug one end of the telephone line cord the jack at the back of the base unit and the other end into modular wall jack.
5.Lift the Handset and check for Dial tone in the earpiece.
Telphone Operation continue...
Inserting a |
| For some switchboard system, an access |
Pause in |
| number must be dialed (usually an 8 or 9) to |
the dialing |
| get another dial tone and an outside line. |
sequence | 1 | Pressing PAUSE button immediately after the |
access number, a pause of about 3.6 seconds will be entered, and the desired number can be dialed immediately.
2
Press PAUSE button to insert a pause when dialing or storing Long Distance Access Codes.
