Spirit EL255 owner manual Connecting Arms and Rear Rail Assembly

STEP 3: CONNECTING ARMS AND REAR RAIL ASSEMBLY

∙Align the hole in the rod end bearings at the ends of the Connecting Arms (7&8) with the hole in the bracket of the Swing Arms. There is a sleeve spacer already installed in the rod ends and held in place with a twist tie; make sure these spacers do not fall out during assembly. The rod end bearing should be positioned to the inside of the swing arm brackets. Install two 5/16" Hex Head Bolts (71) through the left and right swing arm brackets and the rod end and secure with 5/16" Flat Washers (98) and 5/16" Nuts (105).

∙Install the two Rear Rail Tubes (16) to the rear end of the Main Frame (1) and secure with two 3/8￿ x 2-1/4￿ Bolts (76), two 3/8￿ Flat Washers (94) and two 3/8￿ Nuts (89).

∙Install the Rail Stabilizer (15) between the rearward ends of the Rail Tubes (16) and secure with four 3/8￿ x 2-1/4￿ Bolts (76) and 3/8￿ Curved Washers (114).

10 EL255 Elliptical