XE100 / XE200 / XE300 Elliptical
17
UNPACKING THE UNIT
1. Using a razor knife (Box Cutter) cut the outside, bottom, edge of box along the dotted Line. Lift
Box over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged
parts are found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into steps. Remove the to ols first.
Remove the hardware for each step as needed to avoid confusion.
STEP 1: CONSOLE MAST ASSEMBLY
1. Locate the Console Mast (12) and Console Mast Cover (41)and slide the Cover onto the
Mast as far as it will go. Make sure the Console Mast Cove r isfacing the c orrect way.
2. At the top opening of the Main Frameof the elliptical is aComputerCable. Unravel and
straighten out the Computer Cable (31) and feed it into thebottom of the console mast tube
and out of the top opening.
3. Install the Console Mast into the receivingbracket in the top of the Main Frame. NOTE: there
is one boltalready installed in the receiving bracket that will engage with the slot at the bottom
of the Console Mast. This needs to be tightened at the end along with the three otherconsole
mast bolts.
4. Put one 3/8" x2T Split Washer (96) onto the 3/8"x2 -1/4" LongHex Head Bolt (60), and the
two 3/8
"
x 23 CurvedW ashers (84)onto the two 3/8" x 3/4" Short Hex Head Bolts (103).
Install, and handtighten, the Long Hex Head Bolt through the left side of the receiving bracket
into the Console Mast.
NOTE:
There is an electrical wire runni ng thr ough the Console MastTube. Be c areful notto
damage or pinch this Computer Cableduring this procedure. Damage to the Console could
result. Install, and hand tighten, the two Short Hex Head bolts throughthe front of the
receiving bracket into the Console Mast.
5. Using the 13/14m/mW renchtighten the three bo ltsand the fourth b olt,which is pre-installed,
firmly. These bolts should be tightened as much as you possibly can.
6. There willbe three electrical wire connectors at the top opening of the console mast, two 2 pin
connectors (hand pulse sensors)(36) and one 10 pin connector (main wire harness)(31).
Connect these to the mating connectors on the back of the electronic Console (30).The
connectors are keyed, you cannot plug themin the wrong way so do not force them. The two,
2 pin connectors can be plugged into either connector on the back of the console.
7. Storing the excess wire back into the Console Mast, c arefullyinstall the Console onto the
mounting plate of Console Mast and secure using the four M5 x 10m/mPhillips Head Screws.
Make sure the wires do not get pinched between the console and mounting plate.