3Connecting the AIRAVE (continued)
4Plug the power supply connector into the DC 5V power port located at the rear of the base station.
AIRAVE
5 | Insert one end of the power cord into the power supply. | 7 | Move the power switch to the On position. Once on, | |
|
| |||
|
|
|
| the base station will acquire a GPS signal and go |
|
|
|
| through an automated setup sequence. During this |
|
|
|
| time, the unit’s LEDs will change color. When all LEDs |
|
|
|
| have changed to steady blue (stopped blinking), your |
| (to AIRAVE) | (to outlet) |
| device is ready to use. This process may take up to |
|
| one hour. | ||
(to power supply)
6Plug the other end into an available power outlet.
WARNING! Insert the plug from the power cord into the power outlet last. Failure to do so could cause an electrical short or power surge to the base station.
Tip: Once all four lights are steady blue (not blinking), you are ready to use your base station. A short double tone on your wireless phone before making and receiving calls indicates you are within range of the AIRAVE.
Power
System
GPS
WAN
Package Contents
Remove and identify these components:
AIRAVE Base Station
Ethernet Cable | Printed Materials |
GPS Antenna | Power Supply |
Power Cord
Troubleshooting
What if my GPS LED is still red after one hour?
If the GPS LED is still red after one hour, you will need to install the optional GPS antenna. (See “Antenna Installation” in the User Guide.)
How do I know my phone is connecting through the AIRAVE?
By dialing *99 on your wireless phone, an audio message will confirm if you are in range of the AIRAVE. Also, you will hear a short double tone on your wireless phone before making and receiving calls.
For More Information
Check out the AIRAVE User Guide that came with your device.
Visit the the AIRAVE Web site at
www.sprint.com/airave.
Contact Sprint Customer Service at
— or—
©2008 Sprint. Sprint and the logo are trademarks of Sprint. Other marks are the property of their respective owners.
