STORAGE
1. | To store the INTONE Folding Recumbent Bike simply keep it in a clean dry place. |
2. | The minimum folded dimensions of INTONE Folding Recumbent Bike are approximately 21 5/8" long |
| x 25 3/8" wide x 42 1/4" tall. Please measure your INTONE Folding Recumbent Bike if exact dimensions |
3. | are needed. |
The INTONE Folding Recumbent Bike has a pair of MOVING WHEELS(48) built into the FRONT | |
| STABILIZER(4). To move the bike, grasp the HANDRAIL(7), tip the INTONE Folding Recumbent |
| Bike forward slowly, and roll into or out of the storage area. |
4.To avoid damage to the METER(32), remove the batteries before storing the INTONE
Folding Recumbent Bike for one year or more.
5. Follow the illustrated process below to fold the INTONE Folding Recumbent Bike.
a.Loosen the LOCKING KNOB(45). Lift up the BACK SUPPORT(6) and fold it forward. Tighten the LOCKING KNOB(45) after folding.
b.Remove the PULL PIN(47) from the REAR FRAME(2). Fold the REAR FRAME(2) close to the MAIN FRAME(1) and lock it in folded position with the PULL PIN(47).
NOTE: Make sure the LOCKING PIN(47) goes through the holes on both sides of the REAR FRAME(2) and the ring on the MAIN FRAME(1).
A
B
NOTE: When you fold the INTONE Folding Recumbent Bike without changing the seat height or the angle of the METER(32) as described in the steps above and as shown in illustration C, there is no need to readjust your seat height or meter angle before your next workout. You can fold your INTONE Folding Recumbent Bike smaller by following the next step.
c.Loosen and pull the ADJUSTMENT KNOB(41), then lower the SEAT FRAME(5) to the lowest position. Lock the SEAT FRAME(5) into position by releasing and retightening the ADJUSTMENT KNOB(41). Swing the METER(32) down toward the floor as shown in illustration D.
C 
D
12
