Assembled at the factory | Stamina Products 35-1399 manual

ASSEMBLY INSTRUCTIONS

STEP 6

Slide the SEAT(66) onto the RAIL(2). Attach the STOPPER BUMPER(56) to the RAIL(2) with BUTTON HEAD BOLTS(M8x1.25x25mm)(22). Also, please verify that the other STOPPER BUMPER(56) have already been assembled at the factory. If it has not been pre-assembled, then please assemble at this time.

STEP 7

Attach the REAR STAND(3) to the RAIL(2) with a HEX BOLT(M8x1.25x15mm)(59) and a LOCK WASHER(M8)(34) from inside the RAIL(2) and two FLAT HEAD BOLTS(M8x1.25x15mm)(57) from underneath. Tighten all three bolts only after all three have been started. Press the RAIL CAP(53) into the back end of the RAIL(2).

(Assembled at the factory)

10

Image 10

Stamina Products 35-1399 owner manual Assembled at the factory

Contents

This Product is Produced Exclusively by Stamina Products Table of Contents Safety Instructions Call Us First Before YOU Begin Air Rower Equipment Warning & Notice Labels Label is larger than actual size Hardware Identification Chart Assembly Instructions Step Wheel Assembly Instructions Assembled at the factory PINS54 Operational Instructions Using the Fitness MeterHOW to Install and Replace Batteries Function Button Maintenance Storage Conditioning Guidelines WARM-UP and COOL-DOWN Product Parts Drawing Parts List Part Name QTY PART# Part Name QTY Limited Warranty WarrantyPage Page FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO