Stamina Products 45-1003 owner manual Foam GRIPS22

ASSEMBLY INSTRUCTIONS

Slide down the

upper parts of the

FOAM GRIPS(22)

for assembly.

STEP 2

Place the BASE FRAME(1) between the LEFT and RIGHT UPRIGHTS(2, 3) and secure with HEX BOLTS(M12x1.75x75mm)(35) and WASHERS(M12)(45). DO NOT TIGHTEN COMPLETELY.

STEP 3

Slide down the upper parts of the FOAM GRIPS(22), so you can see the screw holes at the back side of the tops of the LEFT and RIGHT UPRIGHTS(2, 3). Connect the UPPER EXTENSION WIRE(26) to the LOWER EXTENSION WIRE(27). Insert the U-SHAPED HANDRAIL(5) into the LEFT and RIGHT UPRIGHTS(2, 3) and secure with BUTTON HEAD BOLTS(M6x1x15mm)(36) and ARC WASHERS(M6)(41). Slide up the FOAM GRIPS(22) to cover the screw heads.

STEP 4

Go back and tighten HEX BOLTS(M12x1.75x75mm)(35) in STEP 2. Connect the LOWER EXTENSION WIRE(27) located on the LEFT UPRIGHT(2) to the SENSOR WIRE(28). Insert the PULL PIN(6) through the RIGHT UPRIGHT(3) and BASE FRAME(1) to lock the BASE FRAME(1) in position.

8